HP

HP Proliant servers | Avoid disconnecting iLO during Firmware update of other server components

Everyone who has worked with HP Proliant servers noticed at least once in their life that the iLO disconnect when you update the firmware to the last build of the server. I mean in the situation when you are working remotely and not on location. I figured out that you can avoid this problem to

HP Proliant servers | Avoid disconnecting iLO during Firmware update of other server components Read More »

HP – Netgear | Trunk configuration between and HP Procurve and a Netgear GSM7352

How to create a trunk between an HP Procurve switch and a Netgear GSM7352S. First I start on the Netgear switch. By going to the Tab: Switching > LAG. Create a new LAG with a useful name/number id. For the trunk it’s best to use the static mode, enable STP and set the Admin Mode

HP – Netgear | Trunk configuration between and HP Procurve and a Netgear GSM7352 Read More »

Cisco | HP server network teaming to Cisco port-channel configuration

If you like to connect a HP server with HP teaming software to an Cisco Catalyst Switch. Than you will need to execute the following steps. Start first on the server. Incase you working with an RDP connection. Go to Launch HP Network ( normally the green network card in the task bar ) select

Cisco | HP server network teaming to Cisco port-channel configuration Read More »

HP Lefthand | Error message when upgrading software (Cannot find one or more files to download from the FTP site. This may be due to activity on the FTP site)

Issues when you try to upgrade Lefthands to a new software version you get the following error. Cannot find one or more files to download from the FTP site. This may be due to activity on the FTP site. Either wait a few minutes and click Try Download Again or try to install the files.

HP Lefthand | Error message when upgrading software (Cannot find one or more files to download from the FTP site. This may be due to activity on the FTP site) Read More »

HP Switching | Configure a Trunk between HP Switch A5120 to a HP Procurve 2626 Switch

Start first to configure the HP switch A5120 to do this you need to connect your computer with a console cable to the switch. And enter the system–view mode. To rename the switch name you can use the command sysname To configure an IP address on the default VLAN interface. (VLAN 1) use the command

HP Switching | Configure a Trunk between HP Switch A5120 to a HP Procurve 2626 Switch Read More »