Switching

Cisco | HP server network teaming to Cisco port-channel configuration

If you like to connect a HP server with HP teaming software to an Cisco Catalyst Switch. Than you will need to execute the following steps. Start first on the server. Incase you working with an RDP connection. Go to Launch HP Network ( normally the green network card in the task bar ) select

Cisco | HP server network teaming to Cisco port-channel configuration Read More »

HP Switching | Configure a Trunk between HP Switch A5120 to a HP Procurve 2626 Switch

Start first to configure the HP switch A5120 to do this you need to connect your computer with a console cable to the switch. And enter the system–view mode. To rename the switch name you can use the command sysname To configure an IP address on the default VLAN interface. (VLAN 1) use the command

HP Switching | Configure a Trunk between HP Switch A5120 to a HP Procurve 2626 Switch Read More »

HP Procurve Switch | Recover boot sequence after removing boot.ini in the Monitor ROM Console.

If you have HP Procurve 2910al switches in the serial number range Than you will face the issue that you aren’t able to upgrade to Firmware version 15.x Via the HP support my collegue got the following commands to try to solve this issue. In boot monitor mode : 0. Monitor ROM Console 1. Primary

HP Procurve Switch | Recover boot sequence after removing boot.ini in the Monitor ROM Console. Read More »

Cisco | SMB Switch SF 302-8P Configuration for wireless APs and Guest-LAN

Few days ago I configured a SF-302-8P cisco switch for usage of WiFi and a guest-LAN. To relize this solution i had to configure a few VLANs. A tip before you start upgrade to the last version of this Switch because than you have the most commond CLI commands in this switch. If you have

Cisco | SMB Switch SF 302-8P Configuration for wireless APs and Guest-LAN Read More »