Start up VEEAM Choose Backup Copy Name the backup and select how often you want to copy a backup. Choose the time also. click on next Select a backup via ADD Select the repository where to backup and select how many restore points you want Select Through build-in WAN Accelerators. Select the local WAN accelerator […]
VEEAM | Create Backup with WAN Accelerator Read More »
How to configure VEEAM WAN Accelerator. Start VEEAM and go to backup Infrastructure > select WAN Accelators > Add WAN Accelerator Select the server where to you want to create this WAN Accelerator > Click on Next Wait till VEEAM is finished the Detecting the server operating system Select the Drive where the Cache folder
VEEAM | How to configure VEEAM WAN Accelerator. Read More »
How to configure DHCP Relay on a HP A5120 switch. To do this you need to go in the system-view of the switch. As followed you need to configured the DHCP Option in the switch. You can do this by: # dhcp enable # Now you need to configure a Server-group where you configure the
HP A5120 Switch | DHCP Relay Read More »
How to connect a HP A5120 switch to a Cisco Small Business Switch 302-8 ( SRW208-8p) First the part of the cisco switch. In my configuration I had more than 1 vlan’s. I wanted that only vlan 1 to 3 are forwarded to the other switch. To do this you need to configure the following
Cisco to HP | Connect a HP A5120 Switch to a Cisco SMB 302-8P Read More »
Installation Message when trying Rollup 2 on Exchange 2010 Service Pack 3 When you are trying to upgrade Microsoft Exchange 2010 SP3 to Rollup 2. You can get a message that Rollup 2 is looking for the file Exchangeserver.msi ( this is a file which you can find in the Service Pack 3 installation files).
Microsoft Exchange 2010| Service Pack 3 Rollup 2 Installation Message Read More »
Issues when you try to upgrade Lefthands to a new software version you get the following error. Cannot find one or more files to download from the FTP site. This may be due to activity on the FTP site. Either wait a few minutes and click Try Download Again or try to install the files.
When you wan to upgrade from version 6.x to version 7 Click on the left yellow block (upgrade) Click on Next Accept the license and click on Next. Veeam Upgrade checks which products are installed on the system > click on Next. Select the license and click on Next. Veeam checks if the system configuration
VEEAM | Upgrade from version 6.x to version 7 Read More »
Start first to configure the HP switch A5120 to do this you need to connect your computer with a console cable to the switch. And enter the system–view mode. To rename the switch name you can use the command sysname To configure an IP address on the default VLAN interface. (VLAN 1) use the command
HP Switching | Configure a Trunk between HP Switch A5120 to a HP Procurve 2626 Switch Read More »
How to setup a Net IPv6 DHCP Scope. I start first with the configuration of the Cisco IOS router. Keep the router configuration as simple as possible for enabling ipc6 traffic. Ipv6 is working good you can proceed further with the security on the IOS Router. Router configuration. IPV6 dns servers previder ip name-server 2001:1690:1:A::53
Windows 2012 DHCP ivp6 and Cisco IOS Router configuration Read More »
For somedays I was struggling with a server where exchange 2013 was located on. I was unable to access the Exchange Admin Center webpage and found out that several important services didn’t start. Note: This issue produce also slow login to the server it takes a while when you can login. When you login it
Exchange 2013 | unable to load Exchange Admin Center ( ECP ) Read More »