How to create a trunk between an HP Procurve switch and a Netgear GSM7352S. First I start on the Netgear switch. By going to the Tab: Switching > LAG. Create a new LAG with a useful name/number id. For the trunk it’s best to use the static mode, enable STP and set the Admin Mode […]
HP – Netgear | Trunk configuration between and HP Procurve and a Netgear GSM7352 Read More »
Recently I had some issues with a few Draytek routers that they were back to default settings and we didn’t have any information from the previous IT supplier. Because of the default settings of the draytek I had to figure out where to find the VPN information. Luckily I found them on the VMware Cloud
Draytek | VPN between Draytek and a VMware Cloud Director Read More »
Since a while i’ve issues with Air-Play in combination with the Linksys E4200. i found across a forum post that the issue was caused by the WMM settings. Which is default on the Linksys software. You have to go to Applications and Gaming > QoS To solve my issue I had to disable the WMM
Linksys | E4200 reboots when using Apple Air-Play Read More »
It happens quite often that you see in your windows explorer on the fileserver where you store the roaming / default profiles of users. And you see only “My Documents” instead of a username To change this you have to change the view settings of windows first for all the folders (temporary) Change the settings
Microsoft | No username on User folder share only the name "My Documents" is displayed Read More »
If you like to connect a HP server with HP teaming software to an Cisco Catalyst Switch. Than you will need to execute the following steps. Start first on the server. Incase you working with an RDP connection. Go to Launch HP Network ( normally the green network card in the task bar ) select
Cisco | HP server network teaming to Cisco port-channel configuration Read More »
Yesterday I walked into an issue that windows 2003 servers and XP systems weren’t able to connect to a network share located on a Windows server 2012 R2. I ran the DFS BPA on the Windows server 2012R2 and saw the following message. Warning Srv.sys should be running. Well I thought I’ve to look how
Yesterday I walked into an error of Windows Server 2012 R2 on Windows server 2012 R2 with Hyper-V. When i tried to install it in a virtual machine generation 2 version. (note: virtual machine generation 1 doesn’t have the issue with Windows server 2012R2) I got the following error: “A virtual disk support provider for
When you use the Best Practice Analyzer for the Domain controller. it’s possible it says that the following root-server (l.root-server.net.) is not anymore available. You see the following error in the DNS To solve this issue you need to lookup what’s the new l.root-servers.net. You can find this information on IANA: http://www.iana.org/domains/root/servers Change the address
I think some people already know but it could be useful to know. How to start powershell when you already opened a command line prompt Run a command prompt in adminsitrative mode To activate powershell. You need to enter the command: Powershell if you type the command: get-help get (You will get all the powershell
Windows | Start powershell direct in the Command Prompt Read More »
How to configure DHCP Relay on a HP A5120 switch. To do this you need to go in the system-view of the switch. As followed you need to configured the DHCP Option in the switch. You can do this by: # dhcp enable # Now you need to configure a Server-group where you configure the
HP A5120 Switch | DHCP Relay Read More »