Configuration Example Wireless for a Cisco Router 87xW

Below I put an example configuration of enabling the Wireless functionality of the Cisco Router Series 870W.
This configuration is easier than what your options are in the webinterface. And now you can disable also the ip http server on the router with no ip http server.

dot11 syslog
!
dot11 ssid EXAMPLE
authentication open
authentication key-management wpa
guest-mode
wpa-psk ascii EXAMPLE
interface Dot11Radio0
description Radio Interface
no ip address
no ip route-cache cef
no ip route-cache
encryption mode ciphers tkip
ssid EXAMPLE
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0
station-role root
world-mode dot11d country NL both
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge irb
bridge 1 protocol ieee
bridge 1 route ip
interface Vlan1
no description LAN ( Description )
no  ip address < IP Address > < Subnet>
no  ip nat inside
no  ip virtual-reassembly
no  ip route-cache same-interface
no  ip route-cache policy
no  ip route-cache flow
no  hold-queue 100 in
no  hold-queue 100 out
no ip address
no ip proxy-arp
bridge-group 1

interface bvi1
description LAN ( Description )
ip address < IP Address > < Subnet>
ip nat inside
no shutdown
ip virtual-reassembly
ip route-cache same-interface
ip route-cache policy
ip route-cache flow
hold-queue 100 in
hold-queue 100 out