If you have HP Procurve 2910al switches in the serial number range Than you will face the issue that you aren’t able to upgrade to Firmware version 15.x Via the HP support my collegue got the following commands to try to solve this issue. In boot monitor mode : 0. Monitor ROM Console 1. Primary […]
Today I received during installation of a Small Business server 2011 an error that the network interface couldn’t be found. I was installing SBS 2011 on a HP Proliant ML 350 G8. Unfortunately I haven’t a print screen of the error. How ever below the solution when you get it. First of all there isn’t
Windows Small Business server 2011 | Can't find any network interface during setup Read More »
Make a Telnet ( when enabled or via the console cable ) a connection the the switch. Type the admin information and when entered a Password ( default no password ) To enable the secret command line commands: you have to type the following command: _cmdline-mode on And press enter. You will get a question.
HP v1910 Secret Commando list ( how to enable it ) Read More »
Today I got the annoying message “No System Management driver is loaded” when I was trying to open the HP Proliant Integrated Management Log Viewer. (Image below) After trying the open the HP Proliant Integrated Management Log Viewer with administrative rights. It seems to work only when you use “Run as administrator”.
HP IML Viewer = Error No System Management driver is loaded Read More »
How to configure a trunk between a VMware server and a HP Procurve Switch. You can decide by yourself what to configured first. I will explainthe settings for the VMware ESX server first and than I will explain the switch configuration. Vmware ESX Server Login to the VMware VCenter Console. Click on an ESX Server
VMWARE & HP | Trunking settings on VMware server and HP Procurve Switch Read More »
How to change power settings via ILO for optimal performance for a system with VMware ESXi of any other Operating system. Logon to ILO and go to Power Management > Settings When you look at the Power Regulator for ProLiant you will see that the HP Dynamic Power Savings Mode is set as default. Change
HP Proliant Server | Best Performance Power settings via ILO Read More »
Removing a Datastore from an Esx server and Lefthand Step 1: go to Home > inventory > datastores Step 2: go to the configuration tab of the specific lun. Step 3: Click on Properties Step 4: disable Storage I/O Control Step 5: wait first on the message that the configuration of Storage I/O Control is
VMware | Delete LUN from ESX and Lefthand (update 18-12-2011) Read More »
1: login to the switch through TELNET OR SSH 2: Standard configuration does not contain a password 3: type configure terminal 4: type a hostname “name of the switch”. 5: Type vlan 1 and configure an ip address 6: Enter a default gateway 7: type ip routing & default route “ip route 0.0.0.0 0.0.0.0 x.x.x.x” When you enable routing, and default
HP Procurve 2910 Switch (routing configuration) Read More »
Some of the readers will probably already know that the HP Procurve switch lines has an stacking command to add new switches into the stacking group. The only thing you will need is that one of the switches is the Stack Commander. To configure a switch as stack commander. you will need the first command
HP Procurve switches and the use of auto-stacking Read More »
How to configure a Netgear Readynas 3200 with 2 lan connections to a HP Procurve 2810-24 or 48 switch. To configure a Netgear Readynas 3200 with 2 lan ports to an HP Procurve 2810-24/48 switch. On the Netgear Readynas 3200 you have to set the LAN connections too. At the tab Ethernet 1 you can
Netgear Readynas 3200 2LAN connection to HP Procurve 2810-XX Switch Read More »