Windows 2012 DHCP ivp6 and Cisco IOS Router configuration

How to setup a Net IPv6 DHCP Scope. I start first with the configuration of the Cisco IOS router.
Keep the router configuration as simple as possible for enabling ipc6 traffic. Ipv6 is working good you can proceed further with the security on the IOS Router.
Router configuration.
IPV6 dns servers previder

ip name-server 2001:1690:1:A::53 (local ISP dns server)
ip name-server 2001:1690:1:C::53 (local ISP dns server)

global settings

ipv6 unicast-routing
ipv6 cef
ipv6 inspect name FW_IPV6_OUT tcp
ipv6 inspect name FW_IPV6_OUT icmp
ipv6 inspect name FW_IPV6_OUT udp
ipv6 inspect name FW_IPV6_OUT ftp

fastethernet interface (internal)

ipv6 address 2XXX:XXXX:XXXX:XXXX::1/64
ipv6 address 2XXX:XXXX:XXXX:XXXX::/64 eui-64
ipv6 enable
ipv6 dhcp server IPV6

interface dialer x

ipv6 unnumbered <internal interface>

default route

ipv6 route ::/0 <wan interface>

Enabling IPv6 on the Windows server 2012.
Go the Windows > DHCP role. Create a new IPv6 scope.

Click on next

Click on next if you want to use the full scope prefix. Click Next.

If you want to exclude a range of ip address you can add it here. Or click Next

Mainly keep this lease standard and click Next
Setup a static ipv6 address for the server and click on ok.

1 thought on “Windows 2012 DHCP ivp6 and Cisco IOS Router configuration”

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.